SwitchID Installation and Removal

[1] PREP - Tighten screws and clean the switchplate with an alcohol based cleaner. OPTION: Remove screw where SwitchID will be placed to ease future removal of plate and create a flat surface for the SwitchID. The plate will stay just fine with only the bottom screw(s).

[2] PLACE - Gently apply the SwitchID over the switchplate screw or on the switch ensuring proper alignment.

[3] PRESS - Firmly press on the entire surface of the SwitchID for complete adhesion once aligned to your satisfaction.

NOTE: Do not use cleaners on your SwitchIDs for 2 days. This could disrupt the adhesive drying process.

For more information, please view our Installation Video.

CLEANING - Made of automotive grade polyurethane SwitchIDs can be cleaned with any house-hold cleaner.

REMOVAL - Carefully work a non-sharp tool, that will not damage/scratch the switch plate, under one edge of the SwitchID until you can grab and remove the SwitchID. For more information, please view our Removal Video

 


  •